Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 4 of 4
Thread: aluminium
-
19th October 2010, 07:40 PM #1Member
- Join Date
- Aug 2007
- Location
- SA
- Posts
- 55
aluminium
I need to make some heatsinks consisting of 60-65mm ID tubing and a 6-10mm circular insert. At the moment I am looking for price ranges of what I should expect to pay and Adelaide suppliers OR interstate if they are reasonably priced.
I'm going to probably make 30ish so I am not after huge lot.
Planning to cut the circles with a hole saw on a drill press and possibly sanding.
An aluminium leg will be threaded into the plate.
The external finish is likely to be powder coating if it's cheap enough. If not paint.
thanks
-
19th October 2010 07:40 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
19th October 2010, 09:00 PM #2SENIOR MEMBER
- Join Date
- Mar 2010
- Location
- Nth Qld
- Posts
- 715
Here's a good article about heatsink design before yoo start powdercoating: ESP - Heatsink design and transistor mounting
-
19th October 2010, 09:55 PM #3Member
- Join Date
- Aug 2007
- Location
- SA
- Posts
- 55
For my use it's not a problem. I may do another finish depending on price but the size is dictated by the fitting I need, not thermal load. With Air flow I can get away with one or two Square cm as a minimum.
-
28th October 2010, 11:55 AM #4Member
- Join Date
- Jun 2009
- Location
- Cootamundra
- Posts
- 69
I buy from these blokes a bit and have found them good.Performance Metals Australia- Home Page
Scott
Similar Threads
-
Aluminium pen
By munruben in forum WOODTURNING - PEN TURNINGReplies: 19Last Post: 12th December 2009, 12:27 AM -
Aluminium
By catbuilder in forum WELDINGReplies: 20Last Post: 4th January 2009, 07:48 PM -
Bending Aluminium Bar
By Dean in forum METALWORK FORUMReplies: 4Last Post: 18th January 2008, 03:53 PM -
Cast aluminium
By masoth in forum METALWORK FORUMReplies: 9Last Post: 28th March 2007, 01:10 PM -
How do I tell if it's aluminium?
By silentC in forum METALWORK FORUMReplies: 44Last Post: 14th February 2007, 08:56 AM