Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 1 of 1
Thread: Brass turning
-
18th February 2020, 03:42 AM #1Most Valued Member
- Join Date
- Aug 2015
- Posts
- 4,431
Brass turning
Ok as I have mentioned before my metal lathe skills are basically try this and if it worked well done pat on back, so advice please, planning g to chuck a a piece of brass appr, 64mm diam
and to put it simply make a couple of rings 4.8 thick, is there any reason why I should not just use a parting off tool on the face and also on the side is, or is there some lathe turning taboo to prevent that
if it was my wood lathe that is what I wood do
Read the full thread at metalworkforums.com...
-
18th February 2020 03:42 AM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Posts
- Many
Similar Threads
-
Turning Brass.
By issatree in forum WOODTURNING - GENERALReplies: 5Last Post: 9th November 2015, 10:29 AM -
Get Your Cheap Turning Brass Here
By thumbsucker in forum WOODTURNING - GENERALReplies: 1Last Post: 19th September 2008, 05:55 PM