Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 1 of 1
Thread: Brass bearings.
-
13th September 2019, 11:10 PM #1Most Valued Member
- Join Date
- Aug 2015
- Posts
- 4,424
Brass bearings.
Hi Guys,
I need some advice !
13-09-2019006.JPG 13-09-2019005.JPG 13-09-2019004.JPG
I've been trying to make some bearings. The pictures show what I've been making !
My issue is whilst holding these in a square ER32 collet block, they are moving and causing the faces to be machined at an angle. I thought that the collet was not tight enough and have tried with a 12" inch wrench to tighten them further, but they still slip round. This is my third lot and is probably the best of the bunch.
The threaded bit is 8 mm in diameter and 10 mm long, the head is 10 mm thick and 18 mm diameter before putting the flats on.
Help !!!
Attached Images
- 13-09-2019006.JPG (110.7 KB)
- 13-09-2019005.JPG (114.4 KB)
- 13-09-2019004.JPG (102.8 KB)
Read the full thread at metalworkforums.com...
-
13th September 2019 11:10 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Posts
- Many
Similar Threads
-
Awning (?) Window Brass Hardware - Where to find solid brass rivets?
By Reno RSS Feed in forum DOORS, WINDOWS, ARCHITRAVES & SKIRTS ETCReplies: 0Last Post: 11th September 2012, 02:38 AM -
what rods for thin brass to brass ??
By Mathuranatha in forum WELDINGReplies: 3Last Post: 6th May 2009, 01:06 AM -
Joining brass male to brass female flared connector
By ubeaut in forum PLUMBING, ELECTRICAL, HEATING, COOLING, etcReplies: 0Last Post: 16th November 2008, 07:10 AM -
Bearings
By smidsy in forum ROUTING FORUMReplies: 10Last Post: 10th November 2005, 09:46 PM