Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 16 to 19 of 19
Thread: C2 P.O.S lathe taper cuts
-
28th May 2015, 04:50 PM #16Member
- Join Date
- Oct 2009
- Location
- Upwey VIC
- Posts
- 95
Kryn,
Bearings for upgrade http://www.ausee.com.au/shop/item.aspx?itemid=1323
As you probably already know, these will fit on both the C2 and the X2.
My X2 shows huge improvement with smoothnees and finish after the bearing upgrade.
Andrew.
-
28th May 2015 04:50 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
28th May 2015, 06:34 PM #17GOLD MEMBER
- Join Date
- May 2011
- Location
- Murray Bridge SA
- Posts
- 3,339
Michael, is ground bar normal Bright Bar?
Andrew, Thank you for that, will follow this up also when this P.O.S. is up to a reasonable standard, ie belt drive, motor not having to be replaced every few months etc.
Kryn
-
28th May 2015, 07:13 PM #18Philomath in training
- Join Date
- Oct 2011
- Location
- Adelaide
- Age
- 59
- Posts
- 3,149
Bright bar can be and for what you are doing it may be good enough for an indicative reading. Ideally a test bar is ground between centres so it is spot on. (Centreless ground (bright) bar can have lobes ground into it so that it is not round. I have a MT2 test bar if you want to borrow it - I don't use it often but every so often it is handy to have
Michael
-
28th May 2015, 07:23 PM #19GOLD MEMBER
- Join Date
- May 2011
- Location
- Murray Bridge SA
- Posts
- 3,339
Thanks Michael, might take you up on your generous offer.
Regards
Kryn
Similar Threads
-
Lathe spindle taper bearing end playadjusment
By iron bark in forum METALWORK FORUMReplies: 7Last Post: 7th January 2014, 10:37 PM -
Mars lathe crosslide scraping and taper gib
By Ueee in forum METALWORK FORUMReplies: 56Last Post: 23rd April 2013, 12:54 AM -
Morse Taper of my lathe?
By Macleod in forum GENERAL & SMALL MACHINERYReplies: 2Last Post: 2nd November 2012, 11:09 AM -
Lathe Taper Attachment Home Made.
By aametalmaster in forum METALWORK FORUMReplies: 3Last Post: 2nd January 2012, 10:46 AM -
Lathe taper attachment made.
By aametalmaster in forum METALWORK FORUMReplies: 8Last Post: 20th May 2011, 01:33 AM