Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 61 to 67 of 67
Thread: chuck troubles
-
21st July 2012, 08:14 PM #61GOLD MEMBER
- Join Date
- Jun 2007
- Location
- sydney
- Age
- 64
- Posts
- 3,566
Is that the best shot you have of the setup.
Was there any provision for counter weights.
Were there recesses cut in the side of the jig plate for the jaws to sit home in.
-
21st July 2012 08:14 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Age
- 2010
- Posts
- Many
-
21st July 2012, 08:43 PM #62Senior Member
- Join Date
- Dec 2011
- Location
- South East Queensland, Australia
- Posts
- 354
Hi Oldnewengine, The chuck may not be tightened up much anyway as there appears to be a through bolt up the spindle holding the fixture against the chuck face and the face of one jaw. Some positioning adjustment is (it appears) achieved by the adjustment bolt acting on the top jaw, fore and aft adjustment of the job could be by moving the job within the clamp plate and base. So the two jaws taking some, somewhat side thrust, may not be taking much anyway.
Cheers.If I'm not right, then I'm wrong, I'll just go bend some more bananas.
-
21st July 2012, 09:16 PM #63Distracted Member
- Join Date
- May 2010
- Location
- Lower Lakes SA
- Age
- 58
- Posts
- 2,557
From the filename I guess it's for turning dodecahedrons. Something like this:
Andrew Stephens - DoDecFixture3.jpg
Every home should have one.
-
21st July 2012, 09:38 PM #641915 17"x50" LeBlond heavy duty Lathe, 24" Queen city shaper, 1970's G Vernier FV.3.TO Universal Mill, 1958 Blohm HFS 6 surface grinder, 1942 Rivett 715 Lathe, 14"x40" Antrac Lathe, Startrite H225 Bandsaw, 1949 Hercus Camelback Drill press, 1947 Holbrook C10 Lathe.
-
21st July 2012, 09:58 PM #65
This is the link to the page.
CNC Cookbook: Blog: April - June 2006
Dean
-
21st July 2012, 10:01 PM #66
-
21st July 2012, 10:05 PM #67
Similar Threads
-
2 pack troubles
By old_picker in forum FINISHINGReplies: 8Last Post: 8th October 2011, 01:22 AM -
Turret Troubles
By Anorak Bob in forum METALWORK FORUMReplies: 38Last Post: 11th July 2011, 08:46 PM -
Gearbox troubles
By bitza500 in forum THE HERCUS AREAReplies: 1Last Post: 6th January 2009, 04:51 AM -
Makita Cut Off Saw Troubles
By under thumb in forum METALWORK FORUMReplies: 13Last Post: 29th June 2007, 05:08 PM