Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 7 of 7
-
15th February 2014, 03:54 PM #1
Very, very close up video of what is happening when cutting on a lathe
An electron microscope view of what your tooltip is doing when it makes a cut.
http://www.youtube.com/watch?feature...&v=mRuSYQ5Npek
-
15th February 2014 03:54 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
15th February 2014, 04:43 PM #2Cba
- Join Date
- Aug 2007
- Location
- Melbourne
- Age
- 68
- Posts
- 1,417
That is a wonderful great clip. I have never seen something like this before.
I like especially at the beginning of it, one can clearly see how the cutting edge is not infinitely sharp. Seen under a microscope it has a radius. And I can somehow imagine what would happen to the material flow, if the depth of cut was gradually diminished. About to the point when the depth of cut approaches 2 times the radius of the tip and cutting would give way to rubbing.
-
15th February 2014, 05:34 PM #3
Thanks for linking to that, incredible video.. amazing to watch the metal ahead of the cutter being pushed along...
Ray
-
15th February 2014, 06:44 PM #4
Wonderful video. Very instructive.
Dean
-
15th February 2014, 08:05 PM #5Senior Member
- Join Date
- Dec 2011
- Location
- Sydney
- Posts
- 178
Thanks, great find!
There's perfect imaging of built up edge formation, and it breaks away on the workpiece side (seen at about 14 sec and another at 33 sec) which I think explains a lot of daggy finish I get on soft and sticky metals esp. mild steel out of the scrapbox.
Bill
-
16th February 2014, 05:56 PM #6GOLD MEMBER
- Join Date
- Jul 2006
- Location
- Adelaide
- Posts
- 2,680
looks just like water being split and forced to flow elsewhere
-
16th February 2014, 06:12 PM #7Distracted Member
- Join Date
- May 2010
- Location
- Lower Lakes SA
- Age
- 58
- Posts
- 2,557
I had seen this before - or rather, an edited version of it.
I'm convinced that built-up edge is responsible for most of my parting problems.
I wonder if there are any DIY coatings you could use at home?
30 degrees, who uses that?
Similar Threads
-
Cutting Concrete Floor Close to Wall
By Reno RSS Feed in forum GENERAL ODDS N SODSReplies: 0Last Post: 31st October 2013, 03:50 AM -
Thread cutting on the lathe ??
By welder in forum METALWORK FORUMReplies: 126Last Post: 27th October 2012, 02:37 PM -
Cutting keyways in the lathe
By shedhappens in forum METALWORK FORUMReplies: 16Last Post: 26th August 2012, 09:56 AM -
Thread cutting with a lathe stop
By colbra in forum METALWORK FORUMReplies: 15Last Post: 15th April 2012, 01:22 AM -
what to buy for sharpening lathe cutting tools
By eddykinn in forum WOODTURNING - GENERALReplies: 6Last Post: 16th December 2009, 05:14 AM