Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 4 of 4
Thread: Crotch Centre for Hercus Lathe
-
30th August 2012, 06:25 PM #1GOLD MEMBER
- Join Date
- Mar 2011
- Location
- Dural NSW
- Age
- 82
- Posts
- 1,120
Crotch Centre for Hercus Lathe
A little while back BT Bob & myself purchased a Crotch Centre each for our Hercus lathes.
These little gadgets came in from the USA & we figured "they might come in handy one day."
The concept of a crotch centres has been around for a long time, in essence a vee block ground into a Morse Taper that fits into the Lathe Tailstock. A simple accurate centreing device.
Yesterday, rather than set up on a drill press in the conventional way, decided to give the crotch centre a test run on a small job.
Two holes for tapped grub screws needed to be drilled on centre for a "Trammel Extender" .140" dia holes for 8-32 UNC
The photo tells it all, however if I were using the crotch again a small toolmakers clamp to hold the workpiece would be recommended. rather than holding with fingers.
regards
Bruce
-
30th August 2012 06:25 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Age
- 2010
- Posts
- Many
-
30th August 2012, 07:50 PM #2future machinist
- Join Date
- Mar 2008
- Location
- nowra
- Posts
- 1,361
Great another thing to add to the I want list. looks useful though
BETTER TO HAVE TOOLS YOU DON'T NEED THAN TO NEED TOOLS YOU DON'T HAVE
Andre
-
30th August 2012, 11:45 PM #3GOLD MEMBER
- Join Date
- Jul 2010
- Location
- Melbourne
- Posts
- 7,775
Certainly on my "might come in handy one day"
Do you know if they are NOS or are they still around?
Stuart
-
31st August 2012, 08:02 AM #4Philomath in training
- Join Date
- Oct 2011
- Location
- Adelaide
- Age
- 59
- Posts
- 3,149
I'm pretty sure there was an MEW article on them a couple of years back. While you could buy one, given that it's a taper with a round V block on the end, making one should be reasonably easy.
Michael
Similar Threads
-
Hercus/Bagear bar-bed spindle centre
By Andrew C in forum THE HERCUS AREAReplies: 8Last Post: 24th April 2012, 01:55 PM -
thinking of buying a centre lathe
By tpjamcc in forum METALWORK FORUMReplies: 1Last Post: 27th April 2011, 12:14 AM -
Dead Centre Size for Hercus Spindle
By wannabe in forum THE HERCUS AREAReplies: 7Last Post: 13th November 2009, 09:52 AM