Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 1 of 1
Thread: More on the cutter grinder
-
7th December 2019, 02:01 PM #1Most Valued Member
- Join Date
- Aug 2015
- Posts
- 4,431
More on the cutter grinder
Here we are again.
The sub plate fitted to the grinder and the work head set up for 4 facet drills. Next step is a micrometer table stop for point splitting and slot drill gashing.
Pic number 3 is of an indexing finger from my Servian tool grinder. Good and solid with a micrometer adjustment. I find these large units quick to fit and they give confidence with the loud click.
Let me know if your getting bored with shapers and tool grinders.
BC
This extension to the grinder works better than expected and does not foul the table operating lever.
SAM_0551.jpgSAM_0552.jpgSAM_0553.jpg
Attached Images
- SAM_0553.jpg (197.4 KB)
- SAM_0551.jpg (156.0 KB)
- SAM_0552.jpg (181.6 KB)
Read the full thread at metalworkforums.com...
-
7th December 2019 02:01 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Posts
- Many
Similar Threads
-
Antique cutter grinder
By wallace1973 in forum ANTIQUE AND VINTAGE MACHINERYReplies: 2Last Post: 16th October 2016, 08:21 PM -
Another Tool And Cutter Grinder
By Anorak Bob in forum METALWORK FORUMReplies: 26Last Post: 13th November 2013, 12:15 PM -
Tool and Cutter Grinder
By Jors in forum METALWORK FORUMReplies: 13Last Post: 17th October 2012, 07:32 AM -
Tool & Cutter Grinder
By graemet in forum METALWORK FORUMReplies: 14Last Post: 20th November 2009, 08:27 AM