Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 4 of 4
-
19th August 2012, 04:52 PM #1
Decorative steel - flat bar supplier
Hi there!
I am going to build a balustrade and would like to use double flat bar for the horizontal section and square tube for the vertical balusters.
I remember a supplier long time ago that had all sort of different decorative patterns for blacksmithing, the one I am after is a flat bar that has a wide groove rolled on one face.
Say it is 40mm wide x 3mm thick, it would have a 30 mm wide 1mm depression in the center of one face.
Something like this: http://www.everettsteel.com/public/p...oducts_id=1220
Anyone knows a supplier?
Kind Regards
Marc“We often contradict an opinion for no other reason
than that we do not like the tone in which it is expressed.”
Friedrich Nietzsche
-
19th August 2012 04:52 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
19th August 2012, 06:45 PM #2Intermediate Member
- Join Date
- Jul 2008
- Location
- TAMWORTH, AUSTRALIA.
- Age
- 78
- Posts
- 31
G'day Marc, try these guys. www.artisticwroughtiron.com.au 1-3 Egerton St, Silverwater. Phone 02)9648-3602
Am sure they can help. Cheers John
-
19th August 2012, 08:54 PM #3
-
19th August 2012, 09:09 PM #4Intermediate Member
- Join Date
- Jul 2008
- Location
- TAMWORTH, AUSTRALIA.
- Age
- 78
- Posts
- 31
Marc if they were it was a long time ago, To my knowledge they have been at Silverwater, I first got some supplies off them about 15 years ago. Cheers John.
Similar Threads
-
Looking for a flat steel
By Sebastiaan56 in forum SHARPENINGReplies: 8Last Post: 6th December 2011, 02:20 AM -
Buying flat bar in grades other then black mild steel
By .RC. in forum METALWORK FORUMReplies: 11Last Post: 28th December 2009, 07:08 PM -
Steel Supplier Melbourne
By Fr_303 in forum METALWORK FORUMReplies: 8Last Post: 25th January 2008, 02:07 PM -
Know of a good decorative inlay supplier ?
By JDarvall in forum WOODWORK - GENERALReplies: 2Last Post: 19th February 2007, 06:27 PM