Thanks: 0
Likes: 
Needs Pictures: 0
Picture(s) thanks: 0
Results 46 to 47 of 47
Thread: Deep hole drilling. MT5 - ER32
-
16th July 2013, 03:19 PM #46
GOLD MEMBER
- Join Date
- Jul 2010
- Location
- Melbourne
- Posts
- 7,775
Hi PC,
I must have got something right as I went out to the shed I have 1.2mm on the cross-slide. I did a couple more light passes to "loosen" things up a little, then bored as above.
No change really.
As always hard to take pictures of blue.
I'd check my measurements then I think I'll just start knocking the compound around until things look better than they do now. I'd like to think it couldn't be far to go
Stuart
-
16th July 2013 03:19 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
16th July 2013, 11:28 PM #47
GOLD MEMBER
- Join Date
- Jul 2010
- Location
- Melbourne
- Posts
- 7,775
Well I think I'm going to call it good.
It might be a little "the other way" now but its almost as good as my compound slide it seems. And I think if its going to be out its better to be out this way than the first way.
Call it half a tenth?1590 - YouTube
Stuart
Similar Threads
-
Drilling a square hole!!
By spidey4fun in forum CNC MachinesReplies: 3Last Post: 14th October 2011, 10:09 PM -
Digging a 3000mm deep hole
By funkychicken in forum NOTHING AT ALL TO DO WITH WOODWORKReplies: 40Last Post: 19th October 2009, 09:24 PM -
OF 1400 & Hole drilling set
By Dustie in forum FESTOOL FORUMReplies: 3Last Post: 26th February 2008, 03:21 PM -
Drilling large hole over small hole or vice-versa
By niki in forum HOMEMADE TOOLS AND JIGS ETC.Replies: 28Last Post: 2nd November 2007, 08:32 PM -
Drilling deep holes
By Roll Tide in forum WOODWORK - GENERALReplies: 14Last Post: 16th June 2007, 01:29 AM
