Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 16 to 17 of 17
-
3rd June 2015, 10:40 PM #16Member
- Join Date
- Jul 2014
- Location
- Alphen aan den Rijn, Netherlands
- Posts
- 67
Michael,
Thanks for the pictures, that helps a lot. I understand what you mean concerning the helix angle, and yours likely is the more practical solution.
The solution I cunjured up was to put the 90° head on the quill, and than rotate this head to the helix angle and mill on top of the blank like on a horizontal mill (clear as mud?). Since there are no angle graduations on the 90° head setting the helix angle might be a challenge though.
Peter
-
3rd June 2015 10:40 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
4th June 2015, 09:28 AM #17SENIOR MEMBER
- Join Date
- Jun 2011
- Location
- Australia east coast
- Age
- 71
- Posts
- 1,469
Similar Threads
-
Bridgeport Series 1 Mechanical feed gearbox
By Garry Edwards in forum METALWORK FORUMReplies: 4Last Post: 11th December 2013, 06:54 AM -
DRO & X axis power feed for RF-30 mill
By iron bark in forum METALWORK FORUMReplies: 10Last Post: 10th September 2012, 10:05 PM -
dividing plates, dividing head
By eskimo in forum METALWORK FORUMReplies: 22Last Post: 4th August 2012, 06:17 PM -
dividing head
By tanii51 in forum METALWORK FORUMReplies: 9Last Post: 18th October 2010, 09:32 AM -
Y axis power feed
By HM52 in forum METALWORK FORUMReplies: 1Last Post: 5th May 2010, 03:46 PM