Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 31 to 33 of 33
Thread: DM 45 power feed
-
2nd February 2012, 11:43 AM #31
Man of Many Talents
- Join Date
- May 2006
- Location
- Canley Heights, Sydney
- Age
- 67
- Posts
- 302
Will you be adding a fast forward and reverse switch or just using the speed controller for that.
Great Setup.
Cheers Shane.
-
2nd February 2012 11:43 AM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Age
- 2010
- Posts
- Many
-
2nd February 2012, 10:31 PM #32
Senior Member
- Join Date
- Jun 2007
- Location
- Vic
- Age
- 48
- Posts
- 200
Hi Stuart, I think I should be able to tidy it up over the weekend, I just need to best location to install the switch. I am not thinking of travel stop at this stage yet, but did think about a box to cover up the gears, the only tricky problem is I need to disengage it with the cover on.
Originally Posted by Stustoys
Jackaroo
-
2nd February 2012, 10:34 PM #33
Senior Member
- Join Date
- Jun 2007
- Location
- Vic
- Age
- 48
- Posts
- 200
Hi Shane, I might not add the fast forward speed, I might just leave it that way for now, I might change the gear ratio to make it a bit faster, currently I have 45 teeth on the drive gear I have 1 spare 32 around
Similar Threads
-
mill power feed
By Garry 3 in forum METALWORK FORUMReplies: 4Last Post: 13th December 2011, 09:54 PM -
Y axis power feed
By HM52 in forum METALWORK FORUMReplies: 1Last Post: 5th May 2010, 03:46 PM -
power feed for a HM-45
By Sterob in forum METALWORK FORUMReplies: 2Last Post: 2nd October 2006, 08:34 PM
