Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 1 of 1
Thread: Turning Double Ended Cones
-
4th March 2021, 01:00 AM #1Most Valued Member
- Join Date
- Aug 2015
- Posts
- 4,433
Turning Double Ended Cones
In Home Shop Machinist Volume 29, Number 2 (March/ April 2010) Page 28 there is Part 2 of an article about an "Anti-gravity Machine" Attached is a scan (jpeg) of the page. Essentially it is a "double" cone piece of steel on a double rail.
I can understand how I would cut one end of the cone shape, but I am struggling with how to cut the second half - and make it exactly the same!
If I had the previous edition ...... I am sure it would have been explained, but I don't!
Any thoughts on a solution would be welcome.
Regards,
Alan.
HSM V29 No.2 P28.jpg
Attached Images
- HSM V29 No.2 P28.jpg (223.3 KB)
Read the full thread at metalworkforums.com...
-
4th March 2021 01:00 AM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Posts
- Many
Similar Threads
-
WANTED:VIC Cap Iron for double ended stanley 110
By dcarbonetti in forum WANTED & WANTED TO BUY - in AustraliaReplies: 0Last Post: 5th January 2021, 08:42 AM -
Double ended boring bars with HSS
By MWF FEED in forum METALWORK FORUMReplies: 0Last Post: 21st November 2018, 04:40 PM -
Double ended bar
By Woody 2 Shoes in forum SMALL TIMBER MILLINGReplies: 8Last Post: 9th September 2015, 03:46 PM -
double ended bar
By david devine in forum SMALL TIMBER MILLINGReplies: 3Last Post: 29th May 2011, 07:48 PM -
double ended pen
By weisyboy in forum WOODTURNING - PEN TURNINGReplies: 3Last Post: 6th December 2007, 07:43 PM