Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 1 of 1
Thread: dovetail cutters again
-
12th October 2020, 06:10 PM #1Most Valued Member
- Join Date
- Aug 2015
- Posts
- 4,434
dovetail cutters again
Hi guys,
I'm looking at buying a couple of dovetail cutters just in case I need one sometime.
Where would I decide to use 60deg, 45deg etc. ? or what's the preference of angle to job type ?
I notice my mill's dove tails are about 60deg so I'd start with one of them I think.
Read the full thread at metalworkforums.com...
-
12th October 2020 06:10 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Posts
- Many
Similar Threads
-
Carbide Cutters for Helical Cutters
By verawood in forum GENERAL & SMALL MACHINERYReplies: 13Last Post: 10th September 2020, 05:11 PM -
Set of dovetail cutters --- why ?
By MWF FEED in forum METALWORK FORUMReplies: 0Last Post: 14th June 2020, 12:41 AM -
Using dovetail cutters
By mav_walrus in forum METALWORK FORUMReplies: 6Last Post: 18th July 2011, 10:30 PM -
Is a Glued Dovetail Joint Stronger Than An Unglued Dovetail
By echnidna in forum WOODWORK - GENERALReplies: 15Last Post: 29th July 2006, 10:03 PM