Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 1 of 1
Thread: Big drill grinder error.
-
18th February 2020, 01:50 PM #1Most Valued Member
- Join Date
- Aug 2015
- Posts
- 4,425
Big drill grinder error.
SAM_0604.jpgSAM_0603.jpgThis old goat made a mistake.
The first shot shows where the grinder finished up. Second shot is where it was first.
While reading thru a cutting tool handbook I realised that as built, the grinding wheel was working parallel to the cutting edge. The edge being ground was vertical and the grain descending on the wheel. This causes the striations to be parallel to the cutting edge and gives stress raisers just behind the edge. You guessed it the drill failed in use. No pic due to temper tantrum. A section 1.5mm X 10mm long peeled off. I would guess 15 thou deep.
With the drill holder re-positioned and now at the bottom of the wheel the striations are at 90 degrees to the edge. I hope it's fixed.
BC
Attached Images
- SAM_0603.jpg (138.3 KB)
- SAM_0604.jpg (195.6 KB)
Read the full thread at metalworkforums.com...
-
18th February 2020 01:50 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Posts
- Many
Similar Threads
-
Big brother drill grinder.
By MWF FEED in forum METALWORK FORUMReplies: 0Last Post: 25th January 2020, 02:50 PM -
Much better drill grinder.
By MWF FEED in forum METALWORK FORUMReplies: 0Last Post: 25th January 2020, 02:00 PM -
My New Pepper Grinder Drill Set
By dai sensei in forum WOODTURNING - GENERALReplies: 2Last Post: 17th February 2017, 10:36 AM -
Drill chuck for grinder
By Strungout in forum HAND TOOLS - POWEREDReplies: 7Last Post: 25th September 2010, 04:41 AM