Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 1 of 1
Thread: Drilmor drill press
-
13th January 2023, 01:40 PM #1Most Valued Member
- Join Date
- Aug 2015
- Posts
- 4,432
Drilmor drill press
I am not sure where to post this question.
I have a drilmore drill press from the 1980 ‘s which has a worn chuck. If you rotate a drill bit in the chuck say 445 deg each time you do that and nib up the chuck the drill runs at varying degrees of being on centre. My thinking is if the quill was bent it would always run off centre no matter where the drill was located in the chuck.
I remember on Canberra member has restored a few of these so hoping some one may have
a) an opinion
b) some advice as to what chuck specs I need and where I might find one.
cheers
Read the full thread at metalworkforums.com...
-
13th January 2023 01:40 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Posts
- Many
Similar Threads
-
N.S.W. Benchtop Drill Press with big differences - versatile Wabeco & Protool Drill Deck
By FenceFurniture in forum WOODWORK - Tools & MachineryReplies: 0Last Post: 3rd July 2022, 04:30 PM -
Drilmor M13 R9 1986. How to dismantle?
By MWF FEED in forum METALWORK FORUMReplies: 0Last Post: 22nd June 2021, 02:20 AM -
Geared drill press vs belt driven press
By Albert in forum GENERAL & SMALL MACHINERYReplies: 20Last Post: 17th October 2016, 12:10 PM -
new drill press: quill stroke vs drill bit length ?
By bannock in forum GENERAL & SMALL MACHINERYReplies: 2Last Post: 21st June 2008, 09:09 AM