Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 1 of 1
Thread: expanding alloy extrusion
-
29th September 2020, 07:20 PM #1Most Valued Member
- Join Date
- Aug 2015
- Posts
- 4,424
expanding alloy extrusion
As far as I know alloy extrusion doesn't want to be bent, much. Or at least not without compromising its strength. But I have a project that requires a sleeve to fit over the top side of a tube extrusion, so I was wondering if a similar section of the tube can be heated and stretched on to make this partial sleeve. I am thinking that the strength isn't that important, but am willing to be corrected. I hope this graphic explains my question a little clearer.
Fwd beam and a frame.JPG
Attached Images
- Fwd beam and a frame.JPG (179.1 KB)
Read the full thread at metalworkforums.com...
-
29th September 2020 07:20 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Posts
- Many
Similar Threads
-
WANTED:N.S.W.. 8020 Extrusion
By Chris Parks in forum WANTED & WANTED TO BUY - in AustraliaReplies: 0Last Post: 31st August 2019, 12:06 PM -
Beam Saw Rubber Extrusion replacement
By Dan.MarvelCabs in forum FURNITURE, JOINERY, CABINETMAKING - formerly BIG STUFFReplies: 0Last Post: 5th July 2018, 04:21 PM -
Cheap Extrusion
By appiwood in forum CNC MachinesReplies: 6Last Post: 22nd December 2008, 10:34 PM -
T-slot aluminium extrusion
By Rocker in forum HOMEMADE TOOLS AND JIGS ETC.Replies: 47Last Post: 29th May 2004, 09:53 PM