Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 3 of 3
Thread: Gas bottle cutting
-
29th April 2009, 02:51 PM #1
Gas bottle cutting
I wish to cut a series of eight tongues in an old disused bbq gas bottle (yes, yes, after being made safe. Please, we are responsible adults on here) but with very narrow kerfs and no burring. Jigsaws and sabre saws immediately come to mind but they are neither accurate or clean enough in their kerfing, particularly given the curved nature of the bottle ends. Water jets also come to mind but this is a home project on a budget.
Ultimately, i want to end up with a series of different sized but most accurate tuned "u" shaped cuts (perhaps square "u" shaped) not much more than 1mm wide. Any suggestions?
-
29th April 2009 02:51 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
29th April 2009, 03:26 PM #2
thin kerf cutof wheel. tehy are 1mm wide
www.carlweiss.com.au
Mobile Sawmilling & Logging Service
8" & 10" Lucas Mills, bobcat, 4wd tractor, 12 ton dozer, stihl saws.
-
29th April 2009, 04:23 PM #3
Similar Threads
-
Bottle Stopper Help
By steiner1000 in forum WOODTURNING - GENERALReplies: 6Last Post: 27th October 2008, 02:01 AM -
A Bottle
By realfEZ in forum SCROLLERS FORUMReplies: 11Last Post: 21st August 2008, 07:30 PM -
old bottle
By hughie in forum WINEReplies: 0Last Post: 14th August 2007, 07:45 PM -
LPG Bottle
By Riverland in forum METALWORK FORUMReplies: 8Last Post: 23rd July 2006, 08:20 PM -
A bottle of Rob
By derekcohen in forum WOODWORK PICSReplies: 2Last Post: 20th October 2003, 04:39 PM