Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 1 of 1
Thread: Gauge Holder !
-
15th April 2020, 04:50 AM #1Most Valued Member
- Join Date
- Aug 2015
- Posts
- 4,432
Gauge Holder !
Hi Guys,
Whilst waiting for a delivery today of a meter of 35 mm diameter EN1AL, I decided to make a new dial gauge holder ! It fits into the lathe tool block in exactly the same way as a normal lathe tool, and is intended to be used for setting work such as this steel bar central in the four jaw chuck though there are other uses.
14-04-2020-001.jpg
This is the device ! A simple piece of 12 mm X 20 mm aluminium bar about 125 mm long. Its drilled 5/16" to accommodate the gauge stem. I used a length of 1.6 mm thick aluminium strip fastened to the end to operate the gauge plunger. As you can see there is a small "L" shaped piece on the strip which extends about 20 mm past the end of the gauge plunger. This was done in order to be able to get close to the chuck jaws without them fouling the gauge. The aluminium strip is secured by a pair of screws in the other end.
14-04-2020-004.JPG 14-04-2020-003.jpg 14-04-2020-002.JPG
These pictures show the device in use. The piece of bar in the lathe four jaw chuck is a 5" long piece of the steel bar that I was waiting delivery of. Interestingly I discovered that the piece of bar actually had a lump in the middle, a little over 5 thou.
Attached Images
- 14-04-2020-004.JPG (149.5 KB)
- 14-04-2020-003.jpg (174.2 KB)
- 14-04-2020-002.JPG (245.9 KB)
- 14-04-2020-001.jpg (192.6 KB)
Read the full thread at metalworkforums.com...
-
15th April 2020 04:50 AM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Posts
- Many
Similar Threads
-
Ring Holder or Cufflink Holder Box
By Pauls321 in forum BOX MAKINGReplies: 3Last Post: 8th March 2016, 09:49 AM -
BXA Boring tool holder and Dial gauge question
By Maxi77 in forum METALWORK FORUMReplies: 8Last Post: 8th November 2014, 10:51 PM -
Marking Gauge Vs Cutting Gauge
By GraemeCook in forum HAND TOOLS - UNPOWEREDReplies: 10Last Post: 11th July 2014, 01:10 AM -
Cutting Gauge or Marking Gauge ???
By GraemeCook in forum HAND TOOLS - UNPOWEREDReplies: 34Last Post: 4th July 2013, 09:07 AM -
Tap Holder
By Anorak Bob in forum METALWORK FORUMReplies: 26Last Post: 5th May 2011, 12:03 AM