Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 16 to 18 of 18
Thread: A Guided Tap Holder.
-
21st September 2012, 11:05 PM #16Senior Member
- Join Date
- Dec 2011
- Location
- South East Queensland, Australia
- Posts
- 354
Gidday,
I wonder what quality difference if any there is between the one's shown by Anorak Bob and Big Shed.
I like both but leaning more towards Anorak Bob's as there seems to be more knurling on the thimble which would make it easier to change/tighten taps on the go when usually I have oily hands doing such operations.
Big Shed's looks like it has grub screws to lock the handle in centre position which I like when using tee type tap holders.
Anorak Bob's are made in USA so I assume should be pretty good, I couldn't find where Big Shed's were made.
Any enlightenment welcomed and appreciated
Cheers.If I'm not right, then I'm wrong, I'll just go bend some more bananas.
-
21st September 2012 11:05 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
21st September 2012, 11:11 PM #17Senior Member
- Join Date
- Dec 2011
- Location
- South East Queensland, Australia
- Posts
- 354
ENCO and CDCO direct links to tap holders
Here's the links direct to the tap handles, save a bit of searching for anyone who hasn't found them yet.
Enco - Guaranteed Lowest Prices on Machinery, Measuring Tools, Cutting Tools and Shop Supplies
CDCO Machinery Corp. Put, Piloted Spindle Tapper, in the search box.
Cheers.Last edited by Log; 21st September 2012 at 11:16 PM. Reason: additional info for CDCO site
If I'm not right, then I'm wrong, I'll just go bend some more bananas.
-
22nd September 2012, 11:31 AM #18.
- Join Date
- Nov 2008
- Location
- Perth WA
- Age
- 71
- Posts
- 5,650
Hello Log,
I reckon the Encos are made in either the orient or the sub continent. I have a few American tap holders and their standard of finish is higher as is their price. The Enco holders along with the Americans, do not offer perfect concentricity, I guess a high expectation from a simple two jaw chuck, but the Encos with their guides are a great convenience. That convenient that I need to buy a few more to save on changing taps. The guide bush has some slop, which could easily be remedied with a new bush.
I learned a lesson when I tapped a 12 x 1 thread using a tap in the Enco. The thread needed to be concentric. It wasn't and I dare say it wouldn't have been using any other tap holder. I had to cut the thread, albeit larger, with a single point tool.
Just like drilling and boring, horses for courses.
BT
ps. I just opened the Enco link . "Made in USA". Well **! I'll take some close ups.
Similar Threads
-
Tap holder
By kraits in forum METALWORK FORUMReplies: 1Last Post: 17th August 2011, 11:39 AM -
Tap Holder
By Anorak Bob in forum METALWORK FORUMReplies: 26Last Post: 5th May 2011, 12:03 AM -
150/3 Holder?
By Lignum in forum FESTOOL FORUMReplies: 7Last Post: 21st October 2009, 07:24 AM -
Laser guided scissors
By jmk89 in forum HAND TOOLS - UNPOWEREDReplies: 10Last Post: 8th May 2008, 10:58 PM