Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 16 to 16 of 16
-
25th September 2012, 03:35 PM #16SENIOR MEMBER
- Join Date
- May 2012
- Location
- Victoria
- Posts
- 130
Bearing wholsales in Bayswater are going to get 1 sent from Singapore, 58 85 8, the difference in width should only be to the caseing and not the rubber seal its self.
I had considered most of the options that everyone is putting up, if the metal outside seal does not turn up I will try taking the sharp edges off the circlip groove and then when I have installed the seal run a bead of blue oil resistant silicone.
Thanks for everyones input.
Cheers
Bruce
-
25th September 2012 03:35 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
Similar Threads
-
HELP NEEDED TO FIND Seal material for windows and doors
By Groggy in forum NOTHING AT ALL TO DO WITH WOODWORKReplies: 25Last Post: 7th March 2013, 03:45 PM -
ELLIOTT OMNITOOL MT 48/4000 Lathe
By argeng in forum METALWORK FORUMReplies: 17Last Post: 2nd July 2012, 07:20 PM -
Metric threading on an imperial lathe
By Vernonv in forum METALWORK FORUMReplies: 9Last Post: 25th October 2010, 07:58 AM -
cutting 3.5mm on 960b lathe with imperial leadscrew
By B the B in forum METALWORK FORUMReplies: 16Last Post: 25th June 2010, 01:28 AM -
Floor Seal for lathe burnishing ?
By barryr in forum FINISHINGReplies: 7Last Post: 30th May 2005, 11:28 AM