Thanks: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 31 to 31 of 31
-
13th July 2012, 06:43 PM #31Awaiting Email Confirmation
- Join Date
- Jul 2010
- Location
- perth
- Posts
- 268
posted by stewart.
Is it 415V only?
100Hz might be a little much to ask of it only running at 240V, wouldn't know haven't tried that.
using a 3kw VSD connected to the UVW1 motor terminals which i believe is the slower speed, 700 rpm and from memory around 1.5KW.
if it's the higher speed then i need to change the motor parameters.
( hope it's a 3KW VFD, as there is no model number or even the huanyang brand anywhere on the inverter.)
ran the lathe in the higher gear and left it on to see what happens,it speeds up, then gradually slows down to a stop. even stranger is the spindle speeds up for a short time when turning it off just before the spindle stops.
( this only happens in the higher gears due to it slowing down after reaching a certain speed).
-
13th July 2012 06:43 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
Similar Threads
-
wiring diagram dw1253
By urric in forum JOINTERS, MOULDERS, THICKNESSERS, ETCReplies: 4Last Post: 17th July 2011, 07:07 PM -
motor wiring diagram
By .RC. in forum METALWORK FORUMReplies: 2Last Post: 12th July 2010, 07:37 PM -
Wiring Diagram HM52
By eskimo in forum METALWORK FORUMReplies: 1Last Post: 30th May 2010, 02:15 PM -
Need wiring diagram for two switches.
By Nurgle in forum DUST EXTRACTIONReplies: 16Last Post: 10th June 2009, 09:09 PM