Thanks: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 31 to 34 of 34
Thread: Hercus chuck problem I think
-
10th April 2014, 03:28 PM #31
Ok more things to check I may be there this weekend and will have a look
I'm learning heaps
Thanks for all the help so far much appreciate
Matt
-
10th April 2014 03:28 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
12th April 2014, 08:53 PM #32
Ok did has was suggested still the same and still happing at the same clock position I think
I think the jaws could be the problem but not sure
Has i don't have new chuck to compare to either
-
12th April 2014, 08:54 PM #33
That is same jaw in all the pics
-
12th April 2014, 10:11 PM #34
Simplicity I admire you perserverence with this endeavour , Have you tried undoing the removable jaws from the main jaws and reversing them,as if you wanted to hold a large flange or such. I am not familiar with this machine ,but the reversing will still allow you to chuck up your test piece ,albeit on a shorter section of jaws , I assume the jaws are held together on the locater step by one or 2 cap head bolts. Before you start try and see which jaw is the culprit,and after reversing see if its the same one or its improved . In use three jaw chucks can get a strained and even bell mouthed ( slightly wider at the tailstock end of the jaws) this can happen from holding short sections of work at the end of the jaws ,the pure mechanical forces of tightening on the front section of the jaws can eventually take the jaws out of parallel , not easily seen to be sure , it just means at times you have a fuller grip on a workpiece it can be out of true . I recently upgraded my baby sieg C3 to a 4" 3 jaw chuck,of course it was out a bit , so I simply set up a dremel with a suitably mounted stone in my tool post and ground the jaws true , its as good as gold now , at least for my purposes hehe, Doesn't hurt to master the 4 jaw if you have one though cheers ~ John
G'day all !Enjoy your stay !!!
Similar Threads
-
Chuck Stops for Hercus 260 Lathe
By Abratool in forum METALWORK FORUMReplies: 35Last Post: 7th July 2012, 07:21 PM -
Hercus Gearing Problem
By Palmfarmer in forum THE HERCUS AREAReplies: 6Last Post: 15th March 2011, 09:03 AM -
ER32 Collet Chuck to Suit Hercus 9 Lathes
By Col2310 in forum METALWORK FORUMReplies: 6Last Post: 10th September 2010, 09:26 AM -
ER32 Collet Chuck to Suit Hercus 9 Lathes
By Col2310 in forum METALWORK FORUMReplies: 4Last Post: 3rd June 2010, 06:22 PM