Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 1 of 1
-
11th October 2020, 01:50 PM #1Most Valued Member
- Join Date
- Aug 2015
- Posts
- 4,431
HM 52 or similar Face Mill Cast Iron
Just curious if any one has been using a 100 or127 or larger face mill runnng SEKT inserts on their machine.
Holder is KM12 type
If so what results are you getting?
What depth of cut are you achieving?
Are you feeding above 100 mm/ min?
What RPM are you running ?
Are you using SEKT or SEHT inserts?
Thank you.
Read the full thread at metalworkforums.com...
-
11th October 2020 01:50 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Posts
- Many
Similar Threads
-
Cleaning Cast iron surfaces : Mill Table & Lathe Ways
By MWF FEED in forum METALWORK FORUMReplies: 0Last Post: 10th November 2019, 02:50 PM -
Cast Iron Coffee Grinder with Ceramic Mill
By Jim Carroll in forum Carroll's Woodcraft Supplies - Something for everyone.Replies: 0Last Post: 14th August 2017, 05:44 PM -
Cast iron fireplace - Question for restoring using Penetrol & Liberon Iron Paste
By mookschank in forum METALWORK FORUMReplies: 8Last Post: 19th June 2013, 06:32 PM -
Cast iron VS Cast steel lathe compound slide
By Ueee in forum METALWORK FORUMReplies: 10Last Post: 23rd December 2012, 11:40 PM -
Riser Block for Mill out of Cast Iron Hollow Bar - where to get the Bar?
By markjaffa in forum METALWORK FORUMReplies: 50Last Post: 8th August 2010, 07:51 PM