Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 1 of 1
-
9th October 2021, 03:10 PM #1Most Valued Member
- Join Date
- Aug 2015
- Posts
- 4,433
Hole tolerance for 3jaw chuck backplate
I have made a back plate for mounting a 150mm 3 jaw chuck. It is a SanOu brand which has 4 8M threaded holes for mounting. I have done the shoulder to fix into the jaw's register. The next step is to drill 4 holes for mounting the chuck. I painted the holes on the jaw and pressed against the back plate. It left an impression on the back plate. I assumed that it should be pretty close.
I have made centre holes first and measured again the distance between 4 holes. However, I have done the centre hole in one go and then 8mm drill bit for holes. I have difficulties on getting the 8 mm drill bit on the centre of the centre hole. I have tried my best to centre the drill. When holes are done, I have no luck of matching them with the threaded holes on the chuck. It needs a lot of precision.
My question is:
1. Should I use 8.5mm drill bit to build in some tolerance.
2. Should I do the centre drill, followed by 8mm drill bit. In that case, centre drill and 8mm drill should be in line
3. What is the best practice of doing this. I am sure that it really requires accuracy and tolerance consideration.
4. What is my option now, perhaps re-drill?
Read the full thread at metalworkforums.com...
-
9th October 2021 03:10 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Posts
- Many
Similar Threads
-
L00 backplate availability
By MWF FEED in forum METALWORK FORUMReplies: 0Last Post: 24th July 2018, 01:50 PM -
For new D-4 Chuck, Backplate or not?
By Spell in forum METALWORK FORUMReplies: 9Last Post: 19th March 2011, 07:14 PM -
Mounting an ER25 chuck on a backplate
By Big Shed in forum METALWORK FORUMReplies: 0Last Post: 3rd October 2009, 05:02 PM