Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 1 of 1
Thread: Lathe headstock adjustment
-
21st March 2020, 09:00 PM #1Most Valued Member
- Join Date
- Aug 2015
- Posts
- 4,432
Lathe headstock adjustment
I just faced off the drill press table, and the result is that it is now cupped in the centre by 0.2mm.
First question is, do I try to get it better?
Second question, if the DIAMETER of the table is 285mm, and the cupping is 0.2mm, do I bump the headstock by 0.1mm at the 285mm point? (or 0.2mm?)
Read the full thread at metalworkforums.com...
-
21st March 2020 09:00 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Posts
- Many
Similar Threads
-
Hafco AL-320G Headstock adjustment
By David J Meakin in forum GENERAL & SMALL MACHINERYReplies: 4Last Post: 19th March 2019, 07:00 PM -
Help with lathe headstock
By tfa in forum WOODTURNING - GENERALReplies: 5Last Post: 15th August 2017, 08:52 PM -
Bowl lathe headstock spindles
By Ueee in forum WOODTURNING - GENERALReplies: 0Last Post: 3rd July 2014, 12:27 AM -
Lathe headstock and tailstock are out of alignment
By 19brendan81 in forum METALWORK FORUMReplies: 24Last Post: 22nd November 2010, 03:00 PM -
Woodfast 280 lathe sliding headstock.
By macca2 in forum WOODTURNING - GENERALReplies: 7Last Post: 1st December 2006, 04:47 AM