Thanks: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 1 of 1
-
21st September 2019, 10:10 PM #1Most Valued Member
- Join Date
- Aug 2015
- Posts
- 4,432
Line boring job to do...looking for inspiration.
I have an old tractor front-end loader that I'm going to be doing a major overhaul on in the next couple of months and it will require at least two line-boring tasks across the width of the loader frame; i.e. two bores about 1200mm apart and each about 100mm deep, that have to be in perfect alignment. I'm at the stage of daydreaming about how I am going to set up the line boring. I would be very interested in seeing what setups people have done, in particular how you have applied feed to the tool. I have an old drill press that I can use for both power and feed to a boring shaft but I think it will be difficult to get a fine enough feed that way. Keen to see how others have done it.
Read the full thread at metalworkforums.com...
-
21st September 2019 10:10 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Posts
- Many
Similar Threads
-
Line boring on the mill
By Ueee in forum METALWORK FORUMReplies: 30Last Post: 5th January 2014, 09:02 AM -
Put My First Line Boring Job on Youtube
By beefy in forum METALWORK FORUMReplies: 9Last Post: 24th June 2013, 11:26 PM -
Large engine metal spraying and line boring
By new_guy90 in forum METALWORK FORUMReplies: 0Last Post: 27th February 2012, 10:00 PM -
I find Boring Boring
By WillyInBris in forum WOODTURNING - GENERALReplies: 7Last Post: 30th May 2007, 05:15 AM