Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 1 of 1
-
20th February 2020, 08:40 AM #1Most Valued Member
- Join Date
- Aug 2015
- Posts
- 4,431
Mill table width information needed
I'm trying to design up a device* to fit on a mill table. My mill is larger than most home mills with a table width of 235mm, so I'm not sure it is the best thing to base a design around. I would like to know what others have got. If you can respond with
- table width
- T-slot width
- T-slot centres
That would help me understand what is out there.
As per the rotary table sizing rule, I don't want to be specifiying a base size that overhangs enough to reduce travel.
*Encouraged by the success of the free vice, I'm trying to knock a few more projects off the 'if only I had something that would hold this' list. This is to make work holding easier for me on those odd occasions but if I'm going to have parts cast, I may as well make them so that they have wide utility.
Michael
Read the full thread at metalworkforums.com...
-
20th February 2020 08:40 AM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Posts
- Many
Similar Threads
-
Diablo 184mm & 254mm 40t body width & riving knife width for table saw?
By Matt NQ in forum WOODWORK - GENERALReplies: 22Last Post: 16th April 2018, 03:13 PM -
Information needed on Empha E30 mill
By Michael G in forum METALWORK FORUMReplies: 0Last Post: 17th January 2013, 06:45 AM -
Information needed
By johnakated in forum SCROLLERS FORUMReplies: 2Last Post: 21st July 2011, 02:18 PM -
Rambaudi Mill Information
By dreinoga in forum METALWORK FORUMReplies: 3Last Post: 2nd March 2011, 10:25 AM -
Information Needed
By Badger in forum TRITON / GMCReplies: 2Last Post: 27th October 2001, 09:34 PM