Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 1 of 1
Thread: Myford ML7 Manual
-
20th October 2021, 11:10 AM #1Most Valued Member
- Join Date
- Aug 2015
- Posts
- 4,432
Myford ML7 Manual
Hi I have been through my stuff again and back to my dads 1961 Myford lathe.
I had to do some screw cutting, and found the manual, so I have scanned it, there are a lot of pages so I think I will have to split it up in to grouped of 10, also its 60 years old so a little hard to read, the original book was green with green print ! so its hard to read the back page...
hope this helps someone, there is some of my dads writing on it which is history..
Happy to answer questions, it might be subject to copyright.....
best wishes
Laurnece
Attached Images
- Myford ML7 Manual P19-20.jpg (242.9 KB)
- Myford ML7 Clutch.jpg (245.4 KB)
- Myford ML7 manual cover.jpg (169.3 KB)
- Myford ML7 Manual inside back.jpg (250.6 KB)
- Myford ML7 Manual P 2-3.jpg (118.1 KB)
- Myford ML7 Manual P1.jpg (113.9 KB)
- Myford ML7 Manual P4-5.jpg (210.2 KB)
- Myford ML7 Manual P6-7.jpg (203.8 KB)
- Myford ML7 Manual P10 -10a.jpg (215.4 KB)
- Myford ML7 Manual P8-9.jpg (224.0 KB)
Read the full thread at metalworkforums.com...
-
20th October 2021 11:10 AM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Posts
- Many
Similar Threads
-
Manual for a Yellow Woodfast C1000 Model 2 (manual speed change)
By Xanthorrhoeas in forum WOODTURNING - GENERALReplies: 11Last Post: 6th September 2016, 10:13 AM -
Myford 7?
By Dalegarth in forum METALWORK FORUMReplies: 4Last Post: 28th November 2011, 07:14 PM -
Myford ml7
By China in forum METALWORK FORUMReplies: 0Last Post: 31st March 2009, 10:19 PM -
Myford ML8
By johnno69 in forum WOODTURNING - GENERALReplies: 5Last Post: 25th February 2008, 10:27 PM -
Is anyone have a Myford ML8 Lathe manual ?
By sinocoin in forum WOODTURNING - GENERALReplies: 3Last Post: 5th December 2004, 10:48 AM