Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 1 of 1
Thread: Nifty thread cutting technique
-
27th March 2024, 12:20 PM #1Most Valued Member
- Join Date
- Aug 2015
- Posts
- 4,466
Nifty thread cutting technique
I thought it was going to be something complex or complicated - the DOC is pretty impressive by itself
https://www.youtube.com/watch?v=CCDP6SFB2Io
Just doing the math on this and for those with more discrete dials, perhaps metric, and smaller machines taking less material per pass setting a ratio of 10:5.6 or 100:56 on infeed versus compound feed yields 29.24 degrees.
So if I was taking 0.25mm cuts I'd advance the compound 0.14 - it also makes it easier as my compound leadscrew has a lot of free play as it is currently, I'd only need to be advancing it, not in and back out, then back in with the occasional overshoot...then rinse repeat
Read the full thread at metalworkforums.com...
-
27th March 2024 12:20 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Posts
- Many
Similar Threads
-
Help with thread cutting - cutting wrong pitch
By MWF FEED in forum METALWORK FORUMReplies: 0Last Post: 14th October 2021, 08:00 PM -
Best technique for cutting slots in SHS
By MWF FEED in forum METALWORK FORUMReplies: 0Last Post: 25th June 2020, 02:41 PM -
Help with Thread cutting
By Tangoman in forum WOODTURNING - PEN TURNINGReplies: 5Last Post: 7th January 2015, 10:21 AM -
Chisel technique, or how to stop cutting my fingers
By gonty in forum HAND TOOLS - UNPOWEREDReplies: 10Last Post: 24th April 2009, 07:27 AM -
thread cutting
By Oldhack in forum METALWORK FORUMReplies: 13Last Post: 9th May 2007, 03:06 PM