Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 2 of 2
Thread: hdpe machineing
-
9th August 2012, 12:08 AM #1danielson
- Join Date
- Dec 2009
- Location
- broadford
- Age
- 63
- Posts
- 237
hdpe machineing
i have a job to quote and am not familiar with one aspect of the job,machining hdpe round bar.i have to get it to a tolerance of about .5mm on 150diam about 350mm long.will it behave?it will be pressed into water pipe.stock will be 160mm.thanks danny
-
9th August 2012 12:08 AM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Age
- 2010
- Posts
- Many
-
9th August 2012, 07:03 AM #2Philomath in training
- Join Date
- Oct 2011
- Location
- Adelaide
- Age
- 59
- Posts
- 3,149
I think you are going to have to try it as it will depend on the grade you are using. Staying within 0.5mm should not be difficult, but I've had situations where I've drilled a hole and then a few minutes later the drill won't go in the hole. Only by a little bit, but it means another pass. I think the material was just relaxing back.
The most important thing to remember with PE is decent DOC and feed rates otherwise you get lots of fluffy stuff coming off.
Michael
Similar Threads
-
HDPE tape
By garfield in forum WOODWORK - GENERALReplies: 11Last Post: 22nd February 2013, 01:19 PM -
Machining HDPE considerations
By BoomerangInfo in forum CNC MachinesReplies: 9Last Post: 11th February 2012, 04:21 AM -
Pearl Ex blending & HDPE sources
By BoomerangInfo in forum CASTING & STABILISATIONReplies: 16Last Post: 23rd December 2011, 10:34 AM -
HDPE supplier
By tony2096 in forum HOMEMADE TOOLS AND JIGS ETC.Replies: 8Last Post: 20th January 2005, 03:08 AM