Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 4 of 4
Thread: Power feed for my mill...
-
11th January 2012, 06:31 PM #1Novice
- Join Date
- Dec 2011
- Location
- Ashburton
- Posts
- 20
Power feed for my mill...
...it looks a bit rough but it does work!
Now I need to make a PWM controller for it and tidy things up a bit..
DSCN0467 | Flickr - Photo Sharing!
-
11th January 2012 06:31 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
11th January 2012, 06:46 PM #2GOLD MEMBER
- Join Date
- Aug 2011
- Location
- Melbourne
- Posts
- 2,951
All you people with your fancy DRO's make me sick!
Nice power feed project though!
Simon
-
11th January 2012, 07:41 PM #3Philomath in training
- Join Date
- Oct 2011
- Location
- Adelaide
- Age
- 59
- Posts
- 3,149
Nice work John. I have mechanical power feed on my mill and one of the nice things about it is that the knock off stops are easily adjustable and very repeatable. How are you planning to implement stops for your mill's power feed?
Michael
-
11th January 2012, 08:11 PM #4Novice
- Join Date
- Dec 2011
- Location
- Ashburton
- Posts
- 20
Michael, you are way ahead of me!
However, with regards to catastrophic running to the end of the table travel the worm wheel is only clamped to the feed screw and would most likely slip before any damage was done, I suppose it would be a good idea if I made that into a real slip clutch.
Limit switches would be nice too, I will look at that tomorrow!
Similar Threads
-
mill power feed
By Garry 3 in forum METALWORK FORUMReplies: 4Last Post: 13th December 2011, 09:54 PM -
Mill power feed break down.
By Retromilling in forum METALWORK FORUMReplies: 14Last Post: 31st October 2010, 08:03 PM -
Power feed for HM-45 Mill....developments
By Sterob in forum METALWORK FORUMReplies: 10Last Post: 13th May 2007, 07:58 PM