Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 1 of 1
-
4th November 2019, 02:50 PM #1Most Valued Member
- Join Date
- Aug 2015
- Posts
- 4,405
Quick Change Tool Post for Hercus 260
seems that I cannot find the right post to find the right recommendation
I am looking to buy the right QCTP for my Hercus 260 - i have two links but not sure which to get -
one is about $100 cheaper (give or take).
I checked as much as I could but cannot determine whether either of these would fit the Hercus 260, because, as far as I understand it is, that the Hercus 260 has a springloaded pin and a bolt to hold the tool post.
I am asking whether anyone could let me know whether either or both of the toolposts in those two links would work, or, what you have bought and installed as a QCTP on your Hercus 260.
Thank you so much in advance
Read the full thread at metalworkforums.com...
-
4th November 2019 02:50 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Posts
- Many
Similar Threads
-
Advice on a quick change tool post for a Hercus 9" ( a gift so I cannot check the fit
By Ben Dono in forum METALWORK FORUMReplies: 3Last Post: 15th December 2014, 07:45 PM -
quick change tool post
By scratchbuilt in forum METALWORK FORUMReplies: 18Last Post: 13th March 2012, 07:46 PM -
Quick Change Tool Post
By tinkera in forum METALWORK FORUMReplies: 3Last Post: 22nd September 2010, 11:17 AM -
Adapting quick change tool post holder to suit Hercus 9" lathe
By neksmerj in forum METALWORK FORUMReplies: 10Last Post: 10th June 2007, 10:37 AM