Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 2 of 2
Thread: Reversed live center.
-
9th January 2012, 10:06 AM #1Senior Member
- Join Date
- May 2011
- Location
- Salem Ohio
- Age
- 65
- Posts
- 214
Reversed live center.
Here was a little job i just finished to use on my SBL when i make plumb bobs. Now i can hold the tail of the bob while i work on the body. Its just a #2MT shaft turned with a boss to hold a 608Z ball bearing...Bob
-
9th January 2012 10:06 AM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Age
- 2010
- Posts
- Many
-
9th January 2012, 02:08 PM #2SENIOR MEMBER
- Join Date
- Apr 2008
- Location
- Canberra
- Posts
- 816
Nice one bob, I like it. I have been looking for a project to practice cutting a MT3 taper...this may just be it.
Similar Threads
-
Non Morse Taper Live Center ?
By Plushy in forum METALWORK FORUMReplies: 5Last Post: 8th November 2010, 10:48 AM -
live center problem
By Daddy3x in forum WOODTURNING - GENERALReplies: 6Last Post: 31st January 2010, 02:49 PM -
Reversed a cigar pen. What to do now?
By clinch in forum WOODTURNING - PEN TURNINGReplies: 12Last Post: 9th October 2008, 09:03 PM -
live center with 1/2 inch thread rather than MT
By dimma20 in forum WOODTURNING - GENERALReplies: 10Last Post: 30th January 2008, 09:07 PM -
Donkey's ear shooting board -- reversed slope
By zenwood in forum HOMEMADE TOOLS AND JIGS ETC.Replies: 26Last Post: 22nd August 2005, 08:08 AM