Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 3 of 3
-
18th March 2012, 01:05 AM #1
.
- Join Date
- Nov 2008
- Location
- Perth WA
- Age
- 71
- Posts
- 5,650
Sandvik Coolant Fed Drill Bit Puzzle
Saw this at a second hand tool shop this morning and was intrigued. Can anyone suggest how they created the coolant passage ways inside the spiral flutes? There are two inlet holes at the rear end of the bit.
BT
-
18th March 2012 01:05 AM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Age
- 2010
- Posts
- Many
-
18th March 2012, 10:46 AM #2
SENIOR MEMBER
- Join Date
- Jul 2011
- Location
- Melbourne Australia
- Posts
- 1,128
Bob.
I have it in the back of my mind someplace that they drill straight holes through the shank, then hold both ends, and induction heat them and put the twist in. Then creep grind the flute’s .
Phil.
-
18th March 2012, 02:49 PM #3
GOLD MEMBER
- Join Date
- Oct 2002
- Location
- NSW
- Posts
- 1,610
Googling from Phil's comment, I found this
:: FORECREU ::
Cheers,
Andrew
Similar Threads
-
Anybody here running Sandvik Capto tool holding system?
By Greg Q in forum METALWORK FORUMReplies: 0Last Post: 4th February 2012, 11:13 PM -
Using Coolant
By simonl in forum METALWORK FORUMReplies: 13Last Post: 22nd December 2011, 10:11 PM -
Sandvik carbide scrapers
By Greg Q in forum METALWORK FORUMReplies: 60Last Post: 17th June 2011, 12:14 AM -
Drill Press Puzzle
By petersemple in forum GENERAL & SMALL MACHINERYReplies: 16Last Post: 18th March 2009, 10:21 AM -
sandvik mitre box
By dennford in forum WOODWORK - GENERALReplies: 9Last Post: 16th August 2007, 03:27 PM
