I have an old Steelfast bandsaw, currently it has a 3/8" wide blade with 14TPI.

I feel I need to acquire a spare blade or two and would like to know where to buy them and what to ask for.
What kind of money should I expect them to cost???

I dont expect to cut anything thicker than 1/4 mild steel and mostly expect to cut much thinner sheet metal mostly and possibly stainless steel sheet on occasions.

Actually today I cut perspex with it and it was OK for what I needed.

I am also wondering if there is a kit to install a roller guide.
Currently, my bandsaw only has friction guides and a rear roller bearing and I'm sure I could improve its performance with side rollers as well.

ANY SHARING OF KNOWLEDGE, EXPERIECE OR THOUGHTS WOULD BE MUCH APPRECIATED.

Oh, anybody knbow what length blades these Steelfast bandswas use???
Attached Images




Read the full thread at metalworkforums.com...