Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 1 of 1
-
7th January 2020, 02:30 PM #1Most Valued Member
- Join Date
- Aug 2015
- Posts
- 4,432
Surface Grinder Travel Less than Mag Chuck
I've recently picked up a Kent KGS-200 Surface grinder
I need to resurface the mag chuck, but I had a look and the chuck is slightly longer than the overall table travel.
This will mean I get high points at each end. Not ideal
Unless anyone's got a better idea, I'm thinking of repositioning the chuck on the table so I can fully traverse to one end, grind that end slightly lower than required. Then shift the chuck and do the same at the other end.
After this I would recentre the chuck and surface the now full traversable surface between the ends.
Any better ideas?
20200107_135534.jpg
IMG_20191223_150343.jpg
IMG_20191223_150353.jpg
Attached Images
- 20200107_135534.jpg (87.3 KB)
- IMG_20191223_150343.jpg (137.8 KB)
- IMG_20191223_150353.jpg (104.2 KB)
Read the full thread at metalworkforums.com...
-
7th January 2020 02:30 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Posts
- Many
Similar Threads
-
Surface Grinder or T&G Grinder, which is best for adapting?
By MWF FEED in forum METALWORK FORUMReplies: 0Last Post: 16th June 2019, 09:33 PM -
surface grinder
By allterrain50 in forum METALWORK FORUMReplies: 4Last Post: 27th April 2014, 04:06 PM -
surface grinder
By Arron in forum METALWORK FORUMReplies: 9Last Post: 16th September 2006, 11:43 AM