Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 5 of 5
Thread: Swarf & Motors
-
28th May 2011, 03:35 PM #1Senior Member
- Join Date
- Apr 2010
- Location
- ringwood vic
- Posts
- 251
Swarf & Motors
G'Day ,
Recently I was boring some aluminium bushes and generating long ribbons of swarf when the end of one entered a ventilation slot on the end of the motor, it pulled in about 300mm before breaking off, no damage done (except to an old blokes bowel control) to prevent a repeat I pilfered a 6" stainless steel skimmer from the kitchen cut the handle off and mounted it over the vent slots with 3mm screws.
Regards,
Martin
-
28th May 2011 03:35 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
28th May 2011, 07:14 PM #2Distracted Member
- Join Date
- May 2010
- Location
- Lower Lakes SA
- Age
- 59
- Posts
- 2,557
Is that an open frame motor? I don't think I'd be very comfortable with that. A lot safer now though. I hope you killed the power before you grabbed the ribbon!
-
28th May 2011, 07:21 PM #3Dave J Guest
Looks like you fixed the problem. The Chinese lathes like mine are covered by the splash back, but I see you have fitted a longer motor so it would sill be a problem if it had one.
Dave
-
28th May 2011, 07:50 PM #4.
- Join Date
- Feb 2006
- Location
- Perth
- Posts
- 27,829
Good move with the skimmer toolman.
I picked another used 1HP 3P today - this one had been in a woodworking lathe.
What I really like about it is that it is really well sealed obviously to keep sawdust out.. It would make a useful metal work lathe motor but I already have that sorted so this one is going on my WW lathe which has a 1/2 HP single phase on it.
I checked out the coil continuity and the earth and it was all good. I've tried it already with the VSB - all good. I'll megger it next week.
-
28th May 2011, 11:01 PM #5Senior Member
- Join Date
- Apr 2010
- Location
- ringwood vic
- Posts
- 251
G'Day,
The motor is a totally enclosed 1.5 Hp variable speed D.C. motor, only the cooling impeller is exposed.
Regards,
Martin
Similar Threads
-
Best Broom For Swarf?
By Bryan in forum METALWORK FORUMReplies: 20Last Post: 13th May 2011, 10:44 PM -
Ferrous swarf
By FenceFurniture in forum METALWORK FORUMReplies: 24Last Post: 16th November 2010, 09:53 PM -
Controlling swarf
By eskimo in forum METALWORK FORUMReplies: 22Last Post: 18th April 2010, 11:25 PM -
swarf pen
By texx in forum WOODTURNING - PEN TURNINGReplies: 10Last Post: 24th March 2010, 10:36 PM -
swarf extractor
By aljenit in forum GENERAL & SMALL MACHINERYReplies: 2Last Post: 29th October 2008, 04:12 PM