Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 1 of 1
Thread: Tough Drill Belt Guard Swap
-
1st March 2021, 01:20 PM #1Most Valued Member
- Join Date
- Aug 2015
- Posts
- 4,431
Tough Drill Belt Guard Swap
There is no provision for swapping in the forum's Market Place so I'm asking the question here.
Does anyone have a cast iron spindle pulley belt guard, as per the first photo, from a late model Tough drill they would swap for a pressed steel guard from a similar late model drill?
The pressed guard will not fit a drill equipped with the low speed intermediate pulley. Sharp eyed Tough aficionados will notice the drill in the second photo has the intermediate pulley fitted. The guard had been brutally modified to accommodate the inverted motor pulley. The guard I wish to swap is in good original condition. The guard comes with the essential cast iron rear support mounting which fits onto the motor mounting rails.
DSC_7913 (Large).jpg DSC_7906 (Large).jpg
Bob.
Attached Images
- DSC_7906 (Large).jpg (202.3 KB)
- DSC_7913 (Large).jpg (142.3 KB)
Read the full thread at metalworkforums.com...
-
1st March 2021 01:20 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Posts
- Many
Similar Threads
-
Change belt on Tough lathe
By Stone Monkey in forum WOODTURNING - GENERALReplies: 13Last Post: 22nd January 2019, 06:05 PM -
WANTED:VIC HYCO jointer belt guard
By greggyboy in forum WANTED & WANTED TO BUY - in AustraliaReplies: 9Last Post: 2nd November 2018, 09:39 AM -
WANTED:VIC HYCO jointer belt guard
By greggyboy in forum WANTED & WANTED TO BUY - in AustraliaReplies: 2Last Post: 1st October 2018, 11:59 AM -
Vertical belt guard repair?
By neksmerj in forum THE HERCUS AREAReplies: 12Last Post: 5th November 2010, 08:54 PM -
Old Belt sander ... needs guard
By nokatze in forum HAND TOOLS - POWEREDReplies: 1Last Post: 10th May 2006, 06:43 AM