Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 1 of 1
-
16th May 2020, 01:40 PM #1Most Valued Member
- Join Date
- Aug 2015
- Posts
- 4,425
New wheels for the tool and cutter grinders.
SAM_0639.jpgHello from BC.
This pic shows some new wheels I got in this week for tool grinding. The selection available has shrunk over the years as usage has dwindled. So I looked in other catagories.
The 2 pink wheels are chainsaw sharpening jobbies. Ruby alox and I suspect a bit hard, also 80 grit. The 22mm center means only for use on the Clarkson unless I make extension shafts. These I will try for tap flute grinding and they are supplied with a radius face.
The white alox wheel is 150 X 6mm 38A60 and multibushed down from 31.75mm. I'll try this wheel on tap chamfer grinding. The Clarkson runs out of room for the tap grinder with a 100mm wheel.
On the right there is a diamond plated wheel for steel cutting using an angle grinder and a Ceramic SS finishing wheel. I'll give these a go for gashing cutters.
All the wheels where well priced I thought. Notice the arrows to show this way up when mounting the wheel.
Regards
BC
Attached Images
- SAM_0639.jpg (247.2 KB)
Read the full thread at metalworkforums.com...
-
16th May 2020 01:40 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Posts
- Many
Similar Threads
-
Power to weight ratio - grinders and cbn wheels
By Gary H in forum SHARPENINGReplies: 3Last Post: 19th April 2020, 05:46 PM -
hafco tc 450 tool and cutter grinders
By sgtfoxhound in forum METALWORK FORUMReplies: 2Last Post: 27th July 2014, 09:35 AM -
For those using diamond wheels on grinders ...
By derekcohen in forum SHARPENINGReplies: 5Last Post: 10th April 2011, 12:07 PM -
Universal tool & cutter grinders
By steran50 in forum METALWORK FORUMReplies: 36Last Post: 22nd January 2011, 08:18 AM -
Fat wheels for grinders.
By Cliff Rogers in forum SHARPENINGReplies: 56Last Post: 23rd October 2007, 03:54 PM