Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 8 of 8
Thread: Zenford NC200
-
5th August 2014, 10:44 PM #1Intermediate Member
- Join Date
- Feb 2013
- Location
- Melbourne
- Posts
- 31
Zenford NC200
Hello forum, an original Zenford mill in Melbourne up for auction on Ebay, this one was used in the Lithgow toolroom as opposed to Steyr rifle production. regards
-
5th August 2014 10:44 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
5th August 2014, 10:46 PM #2Intermediate Member
- Join Date
- Feb 2013
- Location
- Melbourne
- Posts
- 31
-
11th August 2014, 08:33 AM #3New Member
- Join Date
- Aug 2014
- Location
- Australia
- Posts
- 6
Zenford Ziegler
Hello
I am new here I have the ex Tafe Zenford Ziegler Machining Centre with 4th axis I need a Servo card for it It has the ANCA control The card is a TSNM150-10-01 Anyone have one?
I am looking at the one in Melbourne as it has the same control and can get mine running If ok I get the card repaired and have both to use I also have a Hartford HV45S 750 x 450 x 500 and a Femco turning centre 200 x 600 with a 20 tool turret
Peter
-
11th August 2014, 07:08 PM #4Intermediate Member
- Join Date
- Feb 2013
- Location
- Melbourne
- Posts
- 31
I have a few parts, where are you located Peter?
-
11th August 2014, 07:50 PM #5New Member
- Join Date
- Aug 2014
- Location
- Australia
- Posts
- 6
Zenford NC200
Hello
I am in Narellan (South West Sydney) I want the Zenford running to use the 4th ais to make some cams for my radial engine The fault is in the card The error follows the card to whatever axis it is plugged into
Peter
-
11th August 2014, 10:07 PM #6Intermediate Member
- Join Date
- Feb 2013
- Location
- Melbourne
- Posts
- 31
Hello, does your machine use only TSNM drives? The one for sale in Melbourne is using older TSM drives which are connector compatible but mount with different pitching in the card cage. Your best value is to call the agents across town about repairing the TSNM. There have been a few drive name changes over the years ASR -> Baldor -> ABB. The repair expert has fortunately remained the same, ask for Nitin at ABB in Morebank, 9821 0111. He should be able to help you out. regards
-
12th August 2014, 03:01 PM #7New Member
- Join Date
- Aug 2014
- Location
- Australia
- Posts
- 6
NC 200 card
Hello Dave
My mistake it is a TSM 100-10.01 card ABB offer no service for it
Peter
-
12th August 2014, 04:46 PM #8New Member
- Join Date
- Aug 2014
- Location
- Australia
- Posts
- 6
NC 200
Hello
I was underbidder on the Melbourne machining centre Next!!!
Peter
Similar Threads
-
One for Machtool - a Zenford Ziegler Mill
By Anorak Bob in forum METALWORK FORUMReplies: 4Last Post: 10th June 2012, 07:55 PM