Thread: Zenford NC200

this would help

CNC Milling Machine Anca 2000 Zenford Ziegler Manifold in Mitcham, VIC | eBay

Hello
I am new here I have the ex Tafe Zenford Ziegler Machining Centre with 4th axis I need a Servo card for it It has the ANCA control The card is a TSNM150-10-01 Anyone have one?
I am looking at the one in Melbourne as it has the same control and can get mine running If ok I get the card repaired and have both to use I also have a Hartford HV45S 750 x 450 x 500 and a Femco turning centre 200 x 600 with a 20 tool turret
Peter

I have a few parts, where are you located Peter?

Hello
I am in Narellan (South West Sydney) I want the Zenford running to use the 4th ais to make some cams for my radial engine The fault is in the card The error follows the card to whatever axis it is plugged into
Peter

Hello, does your machine use only TSNM drives? The one for sale in Melbourne is using older TSM drives which are connector compatible but mount with different pitching in the card cage. Your best value is to call the agents across town about repairing the TSNM. There have been a few drive name changes over the years ASR -> Baldor -> ABB. The repair expert has fortunately remained the same, ask for Nitin at ABB in Morebank, 9821 0111. He should be able to help you out. regards

Hello Dave
My mistake it is a TSM 100-10.01 card ABB offer no service for it
Peter

Hello
I was underbidder on the Melbourne machining centre Next!!!
Peter