Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 3 of 3
-
14th May 2015, 09:10 PM #1
CA and Deburring by GAWDELPUS 8 May 2015
This post is direct from the email I received from John on the 8th May 2015, in reference to a question on CA sometimes lifting at the ends of a blank.
Quote:
Amos ! these are my most common tools I use ,the rotary deburrer is used to clean the inside corners and put a small chamfer as a lead in for the components when pressing together.
The triangular file is used to scrape the inside of tubes and to cut the CA from the bushes when removing from lathe , I cut in at speed. just longer than the tube and then sand to size (length) on a piece of sandpaper ,holding the tube as close to the paper as possible stops any tipping and off square , works for me hehe. Cheers ~ John
--
gawd_el_pus
end sanding.jpgCA trimming tool 2.jpgCA trimming tool.jpgdeburr and scraper.jpgGood, better, best, never let it rest;
Til your good is better, and your
better, best.
-
14th May 2015 09:10 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Age
- 2010
- Posts
- Many
-
15th May 2015, 06:45 AM #2Skwair2rownd
- Join Date
- Nov 2007
- Location
- Dundowran Beach
- Age
- 76
- Posts
- 19,922
These were tricks shown to me by John some years ago.
it was John who introduced me to the rotary de burring tool.
John was full of hints and tricks, most garnered from his time as a tradesman. I was always
pleased to wrk with John. I just wish it had been more often.
-
15th May 2015, 07:17 PM #3Senior Member
- Join Date
- May 2013
- Location
- South west vic
- Posts
- 343
Amos, thanks for posting John's tip as it is my biggest "let down" (fault) when using C.A, when l try to separate the blank from my plastic bushes it tears about 1 to 2mm up the blank, even when l try and cut it away.
l'll make some chamfered bushes, when l finish my shed extension.
Cheers
Steve
Similar Threads
-
Passing of pen maker Gawdelpus John
By dai sensei in forum WOODTURNING - PEN TURNINGReplies: 59Last Post: 14th September 2015, 08:38 AM -
2015
By planemaker in forum HAND TOOLS - UNPOWEREDReplies: 21Last Post: 3rd January 2015, 05:58 PM -
Australia Day Pen Swap from gawdelpus
By qballizhere in forum WOODTURNING - PEN TURNINGReplies: 6Last Post: 19th February 2012, 01:24 AM