Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 7 of 7
Thread: Question about pricing
-
7th March 2007, 09:39 AM #1Member
- Join Date
- Mar 2007
- Location
- Daphne, AL
- Posts
- 50
Question about pricing
Where can I find out about pricing pens? I haven't even turned one yet but will shortly. Just about to put in my order for some tools and a few slim line kits to get started. I got to thinking that after I get the hang of this what would I charge for a custom pen?
Thanks,
Steve
-
7th March 2007 09:39 AM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
7th March 2007, 10:10 AM #2
what I got told as a guide is add up all your material used and then 3x or some I have heard double it.
hth
Toni
-
7th March 2007, 10:24 AM #3
Roll Tide, this question came up in the Forum recently, basically around $25 for a Slimline, $35 for a Seirra gives a ball park figure, but if you spend big for the parts e.g. Titanium Sierra, or it is a costly blank, or it is a difficult wood and takes you twice as long, then you adjust accordingly, do not sell yourself cheap, if it is quality then the price should reflect that, the labourer is worthy of his hire. Of course there are quite a few variables involved, a little commonsense will soon tell you what is right. Amos
-
7th March 2007, 10:29 AM #4
Roll Tide, I just saw the thread on pricing, it was calle "what Price" and was submitted by Schaf. Amos
-
8th March 2007, 07:00 AM #5Member
- Join Date
- Mar 2007
- Location
- Daphne, AL
- Posts
- 50
Thanks for the info y'all! (I had to put my accent in there ) When I was building rods the norm was to figure up the components at retail and add a minimum $100 labor. Not a lot of folks are willing to pay that much for a custom rod. Thanks for pulling up that thread and I will give it a look.
Thanks,
Steve
-
8th March 2007, 03:37 PM #6
Don't forget that threads talking about $Aussie... but most of it's still perfectly relevant to over t'other side of the big pond.
- Andy Mc
-
9th March 2007, 07:22 AM #7
I followed the hint (advice) from Skew ,and jacked my prices up a little.Still selling a few.
Terry.
Similar Threads
-
Newbee saying G'day, and question about upgrading lathe motor with a bigger one...
By colinshannon in forum METALWORK FORUMReplies: 24Last Post: 27th February 2007, 05:24 PM -
An ROS question sander question for the box makers here
By molarman in forum BOX MAKINGReplies: 13Last Post: 20th February 2007, 02:07 PM -
Two-part Question
By Rodgera in forum WOODIES JOKESReplies: 1Last Post: 12th May 2006, 07:17 PM -
Bow building question
By Grahame Collins in forum WOODWORK - GENERALReplies: 5Last Post: 10th November 2005, 11:52 PM -
Not your usual Table Saw question...
By brucen in forum TABLE SAWS & COMBINATIONSReplies: 15Last Post: 1st May 2005, 09:02 PM