Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 4 of 4
Thread: Woodturner s Pen
-
13th September 2012, 04:48 AM #1
Woodturner s Pen
Here is the third laser cut kit I have done.
Sierra Gold dressed in a laser cut kit consist of Metallic silver acryllic, metallic brass acryllic, coccobolo and curly maple.
The blank is sanded to 600 grit before it is given 5 layers of CA.
Thanks for looking and comments.
woodturnerpen.jpghttp://www.dreiejensen.com
(turningjensen)
-
13th September 2012 04:48 AM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
14th September 2012, 10:05 PM #2SENIOR MEMBER
- Join Date
- Oct 2008
- Location
- Syndey
- Age
- 38
- Posts
- 788
Very nice looking pen. Do you glue the cut pieces in place directly onto a brass tube?
-
15th September 2012, 03:20 AM #3
The instruction says: Lay all the pieces on sheet og white paper. Put the brass tube inside the pen blank (do not glue). Put on all the pieces and fasten them with small rubber band (following the kit). Take out the brass tube and then take on thin CA and set aside to cure. When CA is cured sheck if the brass tube go inside the blank easy, if not wrap a piece of 100 grit sandpaper round a 8 mm dowel and sand until the brass tube go inn. Now it is time to glue, use 5 minutes epoxy - do not use polyuretan glue, that will squeeze out the pieces.
http://www.dreiejensen.com
(turningjensen)
-
15th September 2012, 09:28 AM #4SENIOR MEMBER
- Join Date
- Oct 2008
- Location
- Syndey
- Age
- 38
- Posts
- 788
Thanks for that. I guess the purpose of the CA is just so the epoxy has something to hold onto with a bit of texture
Similar Threads
-
woodturner pro HELP
By brianmary in forum WOODTURNING - GENERALReplies: 0Last Post: 9th March 2009, 04:12 PM -
New 10 yo Woodturner
By Cam the Mad in forum WOODTURNING - GENERALReplies: 18Last Post: 30th October 2008, 12:38 PM -
Apprentice Woodturner
By Seventh Wood in forum WOODTURNING - GENERALReplies: 14Last Post: 9th July 2008, 08:57 PM -
US woodturner needs your help??
By lubbing5cherubs in forum WOODTURNING - GENERALReplies: 10Last Post: 23rd May 2008, 10:07 PM -
American Woodturner mag on CD
By rsser in forum WOODTURNING - GENERALReplies: 5Last Post: 8th July 2007, 06:19 PM