Thread: LS Wonder Fence Question

It's for covering up the holes that you look through to sight the tool you use to make adjustments inside the fence. It locks in place with a black knob. If you don't your vacuum cleaner for dust control will not work as well as it should as it will be able to suck air through the extra holes.

SB

Your wonder fence consists of two box sections an infeed section and an out feed section. When you open / move these apart to accommodate a larger router bit the plastic fits into a channel inside at the back of the sections to maximize dust extraction.

If still I doubt give Grahame Waterson at professional woodworkers supplies as he is Australia's expert in regard to incra products.

Hope this helps

Originally Posted by waikune

Your wonder fence consists of two box sections an infeed section and an out feed section. When you open / move these apart to accommodate a larger router bit the plastic fits into a channel inside at the back of the sections to maximize dust extraction.

Thanks. It worked!

Originally Posted by TORB

Thanks. It worked!

I hope I helped also.

SB

Originally Posted by Superbunny

I hope I helped also.

SB

Hi SB, Oops.... I should have thanked you too. Hower, the part in question does not actually cover up the tool sight holes as you suggested. It is the Inside channel part that waikune suggested.

From the picture both look like bits of black plastic, so its not surprising there were two different responses with two different suggestions.

Thanks again.

Cheers
Ric