Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 5 of 5
Thread: Clamp for RA fixture
-
7th June 2008, 12:34 AM #1New Member
- Join Date
- Nov 2007
- Location
- VA
- Posts
- 4
Clamp for RA fixture
New to Incra & trying to learn dovetail joinery. Am using a Jorgensen wooden hand screw to hold wood to fixture. When I tighten handscrew the wood comes away f/ fence. If I don't thigned it so that wood moves away f/ fence, then wood gets jerked by bit & dovetail is ruined. Try to compensate by pushing RA fixture back toward fence for cut but can't. Any suggestion for clamp/clamping techinque.
-
7th June 2008 12:34 AM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
8th June 2008, 08:34 AM #2
Practice
-
9th June 2008, 04:56 PM #3Intermediate Member
- Join Date
- Jun 2006
- Location
- Sunshine Coast, Qld
- Age
- 84
- Posts
- 31
wooden clamp
Also make sure you either tighten the right angle guide onto the fence using the little screws or use a spring clamp to hold the Right angle fixture firmly onto the fence and table (as in the video) while you apply the wooden clamp
-
20th June 2008, 01:16 AM #4New Member
- Join Date
- Nov 2007
- Location
- VA
- Posts
- 4
Clamps
Thanks guys for response. Watched video again. Started using the lock screw for RA fixture. I was just using clamp to secure it to table but not to fence. Also made sure my wood screw clamp was parallel to wood. Joint turned out a lot better.
-
27th June 2009, 09:25 PM #5
Set up is very important. Routing time is in minutes, but set up takes a bit longer but is worth it. Clamping the RAJ to both the fence and the table is a smart move. Do check the RAJ and the fence for squareness in all 3 planes.
Similar Threads
-
pipe clamp
By haosiliu235 in forum WOODWORK - GENERALReplies: 6Last Post: 4th December 2007, 04:42 PM -
Weld positioner fixture or carvers vice
By Grahame Collins in forum WELDINGReplies: 13Last Post: 20th October 2007, 10:09 AM -
Clamp trolley
By MikeThePom in forum HOMEMADE TOOLS AND JIGS ETC.Replies: 1Last Post: 22nd October 2005, 06:27 PM -
g-clamp repair
By aljenit in forum WOODWORK - GENERALReplies: 0Last Post: 9th December 2004, 10:37 AM -
Additional Clamp
By jow104 in forum HOMEMADE TOOLS AND JIGS ETC.Replies: 3Last Post: 15th October 2004, 10:46 AM