Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 3 of 3
Thread: Mitre 1000SE Setup
-
30th March 2018, 10:19 AM #1SENIOR MEMBER
- Join Date
- Jul 2006
- Location
- Mooroolbark
- Posts
- 522
Mitre 1000SE Setup
Hi, I have just gobe through setting up my Incra 1000se. It's square and zeroed to the blade, all good and happy. Now when i change to a 45' cut the mitre bar fence will need to be moved so as to not hit the blade. My question is does everyone just go through the length recalibration process each time they change angles or is there a better way?
Regards
Peter
-
30th March 2018 10:19 AM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
30th March 2018, 10:30 AM #2SENIOR MEMBER
- Join Date
- Dec 2008
- Location
- Hobart
- Posts
- 153
Just setting mine up as well. You will need to recalibrate the length for the stop each time. I intend to cut two short blocks of known length - one at 90deg and one at 45deg and use them to set to stop. I think that will be easy and accurate.
Cheers
Mike
-
30th March 2018, 03:57 PM #3SENIOR MEMBER
- Join Date
- Jul 2006
- Location
- Mooroolbark
- Posts
- 522
Hi Mike, that sounds like a very smart idea. I think I'll be copying you on that one.
Thanks
Peter
Similar Threads
-
Setup instructions for Lock Mitre bit needed
By Dengue in forum ROUTING FORUMReplies: 3Last Post: 2nd February 2011, 08:25 PM -
Mitre 1000SE. My table slots don't fit.
By RichardL in forum INCRA JIGSReplies: 23Last Post: 18th November 2007, 03:51 PM -
Keg or Incra 1000SE mitre gauge
By greenie512 in forum WOODWORK - GENERALReplies: 5Last Post: 28th December 2006, 10:24 PM -
Incra 1000se
By Ticky in forum WOODWORK - GENERALReplies: 13Last Post: 13th August 2006, 09:31 PM -
Replacement 1000SE
By Jack E in forum INCRA JIGSReplies: 10Last Post: 9th August 2005, 02:27 PM