Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 3 of 3
-
21st March 2008, 05:35 AM #1New Member
- Join Date
- Mar 2008
- Location
- UK (Wales)
- Posts
- 8
Newbie Through Dovetails LS Positioner
Hi peeps
In need of a few pointers badly, trying to joint through dovtails with above router fence setup.
using template DOVS 5/8 with a 5/8 7degree dovetail cutter
centerd the board and set the cutter height to just above the height of the board tail cuts seem to be ok using backing board no tearout.
Now to the tails.... cut the same way as pins without alter cutter height the place board flat onto table and using stop limit the length of cut.
Prob being the tails are far to large to fit the pins tried several different cutter/heights same results Bought my LS brand new before the DVD offer was available trying to locate on in the UK any tips walkthroughs or Valium would be gratefully recieved
Cheers from a confused Taffy
-
21st March 2008 05:35 AM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
21st March 2008, 06:02 AM #2Awaiting Email Confirmation
- Join Date
- Jan 2007
- Location
- Goulburn NSW
- Age
- 89
- Posts
- 913
Have you looked at the Leigh Jig web page they have video's that may help
les
-
21st March 2008, 03:22 PM #3
Stock thickness
Lofty
With Incra's through dovetails there is only one stock thickness for any joint. The DVD shows this, Roger at www.woodworkersworkshop.co.uk should hve the DVD's available, if not, we have them as a 'spare part'
Regards
Grahame
Similar Threads
-
Weld positioner fixture or carvers vice
By Grahame Collins in forum WELDINGReplies: 13Last Post: 20th October 2007, 10:09 AM -
Dovetails
By Sokolic in forum WOODWORK - GENERALReplies: 9Last Post: 26th July 2007, 02:48 PM -
Advice sought on LS Router positioner Vs Ultra 16
By warmtone in forum INCRA JIGSReplies: 0Last Post: 7th March 2007, 09:44 PM -
LS Positioner & Miter1000 on SCM C35 Combi
By Stringy in forum INCRA JIGSReplies: 3Last Post: 25th February 2007, 07:21 PM -
Incra Mike (micro positioner) ??
By scooter in forum WOODWORK - GENERALReplies: 3Last Post: 10th December 2004, 12:47 AM