The key points re LS 17's
Hi
The issues with the size of table for the LS 17" are as follows;- The distance from the centre of cutter to the start of the clamping system should be 500mm,
- The clamping system can sit on a cantilevered extension plate if table size / space is a concern.
- The distance from the front of the router table to the centre of the bit should be, what is comfortable for the operator to be able to see the bit over the workpiece and Right Angle Fixture.
- The distance in 3/ above needs to be large enough to support the RAF and workpiece(s). Ideally 300 - 375mm
A simple way of getting the facts is to look at the Incra LS Instructional DVD, we sell them for $25.00 which is refunded whern the LS is purchased.
I hope that this helps.
Regards
Grahame